Carburettor kit -PINASCO Dellorto PHVB Ø22mm- Vespa Wideframe VM1T, VM2T, VN1T, VN2T, VL1T, VL2T, VL3T, VB, VGL1, ACMA – with intake manifold (fits Pinasco Nordkapp 160cc cylinder only)

Description

Pinasco carburettor kit for the Vespa Wideframe models with headlight on the fender (lamp down, Faro Basso) these are among others Vespa VN, VM

The kit consists of a Dell’Orto PHVB carburettor with Ø22mm and an intake manifold withØ24mm. This is only suitable for Pinasco’s own 160ccm Nordkapp cylinder.
Also included is a very flat foam filter and mounting material.

The carburettor is from the mass production. It was used in the Gilera Runner 125/180 and SKR125/150 models. It has a venturi with an oval surface which corresponds to a cross-section of Ø22mm. This increases conically to the outlet to Ø24mm.
Thus it fits ideally to the intake manifold, which also has an inner diameter of Ø24mm.

The PHVB carburettor has its own muffler type.
The connection between carburettor and intake manifold is made by an enclosed hose.

The carburettor is delivered with the following basic equipment:

• Main nozzle: 102
• Side nozzle: 45
• Needle: W16 (clip at the bottom)
• Slider: 40
• Choke nozzle: fix
• Connection width intake port: Ø29mm
• air filter connection width: Ø40mm

Since the carburettor is intended for use in modern vehicles, it has connections for a vacuum petrol tap and an oil feed for separate lubrication. These are closed with rubber plugs.

AI-translation